Products
Automatic rolling line
Time：2023-05-14 01:28:47　Hits:67
Automatic rolling line
Description of roller press equipment:
Process flow: unwinding → material receiving platform → deviation correction system → edge cutting device → buffer device → dust and iron removal device → roller pressing → roller wiping device (negative electrode applicable) → buffer device → deviation correction system → material receiving platform → winding
Mainly used for the continuous rolling production of lithium-ion battery electrode materials, the battery electrode is rolled to the density and thickness required by the process, and is wound into rolls by a winding mechanism


Technical indicators of roller press equipment

Roll size

φ 800mm × 800mm (roller surface diameter × Effective rolling width

770mm

Roller press size

Approximately 3770mm in length × Width 1360mm × 2850mm high

Single device weight

Total weight of the production line: about 33T, and the weight of the roller press is about 32T

Load bearing requirements

The roller press section requires a ground bearing capacity of ≥ 7t/㎡ and is located at the bottom of the equipment

Place the base plate

Air requirements

0.5Mpa~0.7Mpa (oil and water removal), flow rate: 0.04M3/min

Environmental requirements

Temperature range 0~+45 ℃ Relative humidity: ≤ 50%

Power requirements

380V, 50Hz three-phase five wire system

Whole line power

Power 40KW

rolling speed

Max.32m/min

Pressure between two rollers

Max.400T

Pass rate

≥ 99.8% (excluding defective incoming materials)

equipment failure rate

≤ 1% (excluding factors such as poor incoming materials and factory power and gas supply)


Previous:Double-sided coating machine
Next:Cutting and stacking integrated machine